PROCEDURE FOR INSTALLATION HEADSTOCK MOUNTING BRACKET

  1. Home
  2. Heavy Duty Penstock
  3. Installation
  4. PROCEDURE FOR INSTALLATION HEADSTOCK MOUNTING BRACKET

PROCEDURE FOR INSTALLATION HEADSTOCK MOUNTING BRACKET


  1. Headstock bracket mount by the anchor bolts to the wall or floor. Check the top surface and make sure is align perpendicularly with the stem is pass through the center of the stem slot.
  2. After the headstock bracket is install completely, put on the headstock on top of the bracket and mount with four bolts and nuts.
  3. Make sure the headstock is in proper alignment all the time.
  4. After install the headstock is in proper alignment all the time.
  5. After install the headstock, apply the tension to the stem by lifting the penstock. Align the stem guides and tighten the stem guide assembly bolts.

Setting Position Indicators (Non-Rising)

  1. When installing the manual headstock, make sure the penstock is in FULLY CLOSE position.
  2. Set the headstock indicator to FULLY CLOSE position by turning the handwheel.
  3. Position the headstock to the bracket or slab and align properly to the stem.
  4. Connect the stem with the headstock shaft by the muff coupling and tighten the the muff coupling.
  5. Secure the headstock to the wall bracket or slab by tighten the 4 nos. mounting bolts.

Setting Position Indicators (Rising)

  1. When installing the manual headstock, make sure the penstock is in FULLY CLOSE position.
  2. Position the headstock to the bracket or slab and align properly to the stem.
  3. Connect the stem with the headstock shaft by the muff coupling and tighten the the muff coupling.
  4. Secure the headstock to the wall bracket or slab by tighten the 4 nos. mounting bolts.
  5. To install the indicator, first of all, secure the rising thrust nut with nut lock and handwheel.
  6. Put on the 2 pieces of locking plate into the slot on top of the thrust nut and put on the indicator ring onto the headstock shaft.
  7. Put on the stem cover and tighten it with locking plate by 4 nos. of screws.
  8. After secure the stem cover, adjust the indicator ring to the FULLY CLOSE position and screw on the indicator pointer onto the ring by the screw.